|
|
|
|
||||||
|
The Tire Rack's Tire & Wheel Forum
Use this forum to discuss anything in relation to wheels to tires to offsets. Sponsored by The Tire Rack |
 |
|
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
08-13-2012, 11:04 PM
|
#1 |
|
Registered User
|
Yet another non m fitment question :(
Is anyone running 19x9.5 et +35 on the rear of their E46 non M coupe ? And if so, what tyre size ?
Or does anyone know if this will fit without too much drama ?......I want to run reasonably low, but not crazy as it's my daily ride. Searched for this, but can't find anyone running this exact setup Any help greatly appreciated Really sorry if this has been covered a million times, but I'll be stuffed if I could find the info I'm after...... |
|
|
|
08-13-2012, 11:06 PM
|
#2 |
|
Registered User
|
Jizzo330 is running them. Check pyspeed.com under vmr v710s and the tires they recommend fit perfect
Sent from my DROID RAZR using Bimmer App |
|
|
|
08-13-2012, 11:39 PM
|
#3 |
|
i <3 my e46
|
I'm running that exact setup on the back with some Toyo 255/30r19 tires. My drop would be moderate/low but not slammed. I'm rubbing a lot even on little dips with a fender roll as well. I can camber my wheels in a little bit beyond the factory specs I suppose, but I do not want to kill my tires prematurely as well. So if I were u, I'd suggest either getting a narrower tire or lower your car just a bit (as I had little rubbing on the rears when my car was raised up about 3/4 to 1 inch).
__________________
 Hamann/Euro-Spec/AA/Tein/Work Meister |
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
